Rohde & Schwarz FSVA - CALCulate:MARKer:FUNCtion:STRack Subsystem

Remote Control
R&S
®
FSVA/FSV
712Operating Manual 1176.7510.02 ─ 09
Parameter Standard
CDMA J-STD008 REV CDMA J-STD008 reverse
CDMA IS95C Class 1 FWD CDMA IS95C Class 1 forward
CDMA IS95C Class 1 REV CDMA IS95C Class 1 reverse
CDMA 2000 CDMA 2000
TD SCDMA FWD TD-SCDMA forward
TD SCDMA REV TD-SCDMA reverse
WLAN 802.11A WLAN 802.11A
WLAN 802.11B WLAN 802.11B
WiMAX WiMAX
WIBRO WIBRO
RFID 14443 RFID 14443
EUTRa EUTRA/LTE Square
REUTra EUTRA/LTE Square/RRC
TETRA TETRA
PDC PDC
PHS PHS
CDPD CDPD
GSM GSM
CALCulate:MARKer:FUNCtion:STRack Subsystem
The CALCulate:MARKer<m>:FUNCtion:STRack subsystem defines the settings of the
signal track.
CALCulate<n>:MARKer<m>:FUNCtion:STRack:BANDwidth|BWIDth.................................. 712
CALCulate<n>:MARKer<m>:FUNCtion:STRack:THReshold...............................................713
CALCulate<n>:MARKer<m>:FUNCtion:STRack:TRACe.................................................... 713
CALCulate<n>:MARKer<m>:FUNCtion:STRack[:STATe]................................................... 714
CALCulate<n>:MARKer<m>:FUNCtion:STRack:BANDwidth|BWIDth <Bandwidth>
This command defines the bandwidth around the center frequency that is included in
the signal tracking process.
Note that you have to turn on signal tracking before you can use the command
(CALCulate<n>:MARKer<m>:FUNCtion:STRack[:STATe]).
Suffix:
<n>
.
Selects the measurement window.
<m> Selects the marker.
Remote Control – Commands