Rohde & Schwarz FSVA - 3.2 Measurement Parameters

Instrument Functions
R&S
®
FSVA/FSV
215Operating Manual 1176.7510.02 ─ 09
2. In the file selection dialog, select a stored settings file to be recalled when the soft-
key is selected.
3. Click "Select".
The selected file is displayed in the "ApplicationManager" dialog.
To store the softkey settings
► Click "Save" to store the user-defined softkey definitions.
3.2 Measurement Parameters
In this section all menus necessary for setting measurement parameters are described.
For details on changing the mode refer to Chapter 3.4.1, "Measurement Mode Selec-
tion – MODE Key", on page 435.
Editing measurement parameters in the information bar
The currently defined main measurement parameters are displayed in the information
bar of the display. They can easily be edited by touching the setting in the display (with
a finger or mouse pointer). The corresponding (edit) dialog box is displayed where you
can edit the setting.
If you touch the setting in the display longer than 1 second or right-click it, a context-
sensitive menu is displayed. The entries correspond to the functions available in the
softkey menu for that setting.
Table 3-1: Sweep range variables
Abbrev
.
Definition R&S FSVA/
FSV4 value
R&S FSVA/
FSV7 value
R&S FSVA/
FSV13 value
R&S FSVA/
FSV30 value
R&S FSVA/
FSV40 value
f
max
max. fre-
quency
4 GHz 7 GHz 13.6 GHz 30 GHz 40 GHz
f
min
min. fre-
quency
available
0 Hz 0 Hz 0 Hz 0 Hz 0 Hz
span
min
smallest
selectable
span > 0
Hz
10 Hz 10 Hz 10 Hz 10 Hz 10 Hz
● Initializing the Configuration – PRESET Key........................................................ 216
● Selecting the Frequency and Span – FREQ Key..................................................218
● Setting the Frequency Span – SPAN Key.............................................................223
● Setting the Level Display and Configuring the RF Input – AMPT Key.................. 225
● Defining Automatic Settings – AUTO SET Key.....................................................233
● Setting the Bandwidths and Sweep Time – BW Key............................................ 237
Measurement Parameters