Rohde & Schwarz FSVA - 4.2.4 Remote Control - Description of Measurement-Independant Commands; 4.2.4.1 CALibration Subsystem

Remote Control
R&S
®
FSVA/FSV
914Operating Manual 1176.7510.02 ─ 09
) 1 byte
<Value> Data values, each one is a 4-byte floating point value
Example:
#(1677721600)<value 1><value 2> ... <value 419430400>
(1677721600): 1677721600 Bytes of following data; float: 4 Bytes / value ==>
1677721600/ 4 = 419430400 values (200Ms I and 200Ms Q values)
<value x>: 4 Byte values, must be interpreted as float
4.2.4 Remote Control – Description of Measurement-Independant Com-
mands
In this section all remote control commands that are independant of a particular mea-
surement mode are described in detail.
For details on specific "Spectrum" mode commands refer to Chapter 4.2.3, "Remote
Control – Description of Analyzer Commands", on page 612.
4.2.4.1 CALibration Subsystem...............................................................................................914
4.2.4.2 DIAGnostic Subsystem............................................................................................... 916
4.2.4.3 DISPlay Subsystem.................................................................................................... 923
4.2.4.4 CMAP Suffix Assignment............................................................................................928
4.2.4.5 FORMat Subsytem......................................................................................................930
4.2.4.6 HCOPy Subsystem..................................................................................................... 930
4.2.4.7 MMEMory Subsystem.................................................................................................936
4.2.4.8 OUTPut Subsystem (Option Additional Interfaces, B5).............................................. 950
4.2.4.9 SENSe Subsystem......................................................................................................950
SENSe:CORRection Subsystem................................................................................ 950
SENSe:ROSCillator Subsystem..................................................................................954
4.2.4.10 SOURce Subsystem................................................................................................... 955
SOURce:TEMPerature Subsystem.............................................................................955
SOURce:EXTernal Subsystem................................................................................... 956
4.2.4.11 STATus Subsystem.................................................................................................... 956
4.2.4.12 SYSTem Subsystem...................................................................................................960
4.2.4.1 CALibration Subsystem
The commands of the CALibration subsystem determine the data for system error cor-
rection in the instrument.
Remote Control – Commands