Remote Control
R&S
®
FSVA/FSV
656Operating Manual 1176.7510.02 ─ 09
Parameters:
<Power> 33 | 28 | 0
33
P ≥ 33
28
28 < P < 33
0
P < 28
*RST: 0
Example:
CALC:LIM:ESP:VAL 33
Activates manual selection of the limit line and selects the limit
line for P = 33.
CALCulate:LIMit:LOWer Subsystem
The CALCulate:LIMit:LOWer subsystem defines the lower limit line.
CALCulate<n>:LIMit<k>:LOWer[:DATA]........................................................................... 656
CALCulate<n>:LIMit<k>:LOWer:MARGin......................................................................... 657
CALCulate<n>:LIMit<k>:LOWer:MODE............................................................................657
CALCulate<n>:LIMit<k>:LOWer:OFFSet.......................................................................... 657
CALCulate<n>:LIMit<k>:LOWer:SHIFt............................................................................. 658
CALCulate<n>:LIMit<k>:LOWer:SPACing........................................................................ 658
CALCulate<n>:LIMit<k>:LOWer:STATe............................................................................659
CALCulate<n>:LIMit<k>:LOWer:THReshold..................................................................... 659
CALCulate<n>:LIMit<k>:LOWer[:DATA] <LimitLinePoints>
This command defines the vertical definition points of a lower limit line.
If the measured values are smaller than the LOWer limit line, the limit check is violated.
The units DEG, RAD, S, HZ, PCT are not available in the "Spectrum" mode.
Suffix:
<n>
.
irrelevant
<k> 1...8
Selects the limit line.
Parameters:
<LimitLinePoints> Variable number of x-axis values.
Note that the number of horizontal values has to be the same as
the number of vertical values set with CALCulate<n>:
LIMit<k>:CONTrol[:DATA]. If not, the R&S FSVA/FSV
either adds missing values or ignores surplus values.
The unit depends on CALCulate<n>:LIMit<k>:UNIT.
*RST: (LIMit:STATe is set to OFF)
Remote Control – Commands
To Next Page
Loading...
