Rohde & Schwarz FSVA - SENSe:POWer Subsystem

Remote Control
R&S
®
FSVA/FSV
841Operating Manual 1176.7510.02 ─ 09
Mode: PSM
Manual operation: See "Slope" on page 550
[SENSe:]PMETer<p>:UPDate[:STATe] <State>
This command switches the continuous update of the power sensor measurement for
the selected power sensor on or off. If activated, even after a single sweep has been
completed, the data from the power sensor is updated.
Suffix:
<p>
.
1...4
Power sensor index
Parameters:
<State> ON | OFF
*RST: OFF
Example:
PMET1:UPD ON
The data from power sensor 1 is updated continuously.
Mode: PSM
Manual operation: See "Continuous Value Update" on page 546
SENSe:POWer Subsystem
This subsystem controls the setting of the instruments channel and adjacent channel
power measurements.
[SENSe:]POWer:ACHannel:ACPairs................................................................................842
[SENSe:]POWer:ACHannel:BANDwidth|BWIDth[:CHANnel<channel>]................................842
[SENSe:]POWer:ACHannel:BANDwidth|BWIDth:ACHannel................................................842
[SENSe:]POWer:ACHannel:BANDwidth|BWIDth:ALTernate<channel>................................ 843
[SENSe:]POWer:ACHannel:FILTer:ALPHa:ACHannel....................................................... 843
[SENSe:]POWer:ACHannel:FILTer:ALPHa[:ALL]...............................................................843
[SENSe:]POWer:ACHannel:FILTer:ALPHa:ALTernate<channel>........................................844
[SENSe:]POWer:ACHannel:FILTer:ALPHa:CHANnel<channel>..........................................844
[SENSe:]POWer:ACHannel:FILTer[:STATe]:ALL...............................................................844
[SENSe:]POWer:ACHannel:FILTer[:STATe]:ACHannel......................................................845
[SENSe:]POWer:ACHannel:FILTer[:STATe]:ALTernate<channel>...................................... 845
[SENSe:]POWer:ACHannel:FILTer[:STATe]:CHANnel<channel>........................................845
[SENSe:]POWer:ACHannel:MODE..................................................................................845
[SENSe:]POWer:ACHannel:NAME:ACHannel...................................................................846
[SENSe:]POWer:ACHannel:NAME:ALTernate<channel>................................................... 846
[SENSe:]POWer:ACHannel:NAME:CHANnel<channel>.....................................................846
[SENSe:]POWer:ACHannel:PRESet................................................................................ 847
[SENSe:]POWer:ACHannel:PRESet:RLEVel.................................................................... 847
[SENSe:]POWer:ACHannel:REFerence:AUTO ONCE....................................................... 848
[SENSe:]POWer:ACHannel:REFerence:TXCHannel:AUTO................................................848
[SENSe:]POWer:ACHannel:REFerence:TXCHannel:MANual............................................. 848
[SENSe:]POWer:ACHannel:SPACing[:ACHannel]............................................................. 849
[SENSe:]POWer:ACHannel:SPACing:ALTernate<channel>............................................... 849
Remote Control – Commands