Quick Start
R&S
®
FSVA/FSV
14Operating Manual 1176.7510.02 ─ 09
Function key Assigned functions
MEAS
Provides the measurement functions:
●
Measurement of multicarrier adjacent channel power (Ch Power
ACLR)
●
Carrier to noise spacing (C/N C/No)
●
Occupied bandwidth (OBW)
●
Spectrum emission mask measurement (Spectrum Emission Mask)
●
Spurious emissions (Spurious Emissions)
●
Measurement of time domain power (Time Domain Power)
●
Signal statistics: amplitude probability distribution (APD) and cumu-
lative complementary distribution function (CCDF)
●
Third-order intercept point (TOI)
●
AM modulation depth (AM Mod Depth)
MEAS CONFIG Used to define measurement configuration.
LINES Configures display lines and limit lines.
INPUT/OUTPUT Displays softkeys for input/output functions.
Measurement start functions
RUN SINGLE Starts a single new measurement (Single Sweep Mode).
RUN CONT Starts a continuous measurement (Continuous Sweep Mode).
Function execution
UNDO Reverts last operation.
REDO Repeats previously reverted operation.
2.1.1.2 Touchscreen Display
All measurement results are displayed in the screen on the front panel. Additionally,
the screen display provides status and setting information and allows you to switch
between various measurement tasks. The screen is touch-sensitive, offering an alter-
native means of user interaction for quick and easy handling of the device.
Risk of touchscreen damage during operation
Inappropriate tools or excessive force can damage the touchscreen.
Observe the following instructions when operating or cleaning the touchscreen:
●
Never touch the screen with ball point pens or other pointed objects with sharp
edges.
●
It is recommended that you operate the touchscreen by finger only.
As an alternative, you can use a stylus pen with a smooth soft tip.
●
Never apply excessive force to the screen. Touch it gently.
●
Never scratch the screen surface, for example with a finger nail.
Never rub it strongly, for example with a dust cloth.
Front and Rear Panel View
To Next Page
Loading...
