Rohde & Schwarz FSVA - 4.2.3.18 SYSTem Subsystem

Remote Control
R&S
®
FSVA/FSV
881Operating Manual 1176.7510.02 ─ 09
Example:
STAT:QUES:SYNC:ENAB 65535
Mode: This command is required by the firmware applications only.
STATus:QUEStionable:SYNC:NTRansition <BitDefinition>
This command sets the edge detectors of all bits of the
STATus:QUEStionable:SYNC register from 1 to 0 for the transitions of the "CONDi-
tion" bit.
Parameters:
<BitDefinition> 0 to 65535
Example:
STAT:QUES:SYNC:NTR 65535
Mode: This command is required by the firmware applications only.
STATus:QUEStionable:SYNC:PTRansition
<BitDefinition>
This command sets the edge detectors of all bits of the
STATus:QUEStionable:SYNC register from 0 to 1 for the transitions of the "CONDi-
tion" bit.
Parameters:
<BitDefinition> 0 to 65535
Example:
STAT:QUES:SYNC:PTR 65535
Mode: This command is required by the firmware applications only.
4.2.3.18 SYSTem Subsystem
SYSTem:COMMunicate:GPIB:RDEVice:COMMand.......................................................... 881
SYSTem:COMMunicate:GPIB:RDEVice:GENerator<generator>:ADDRess..........................882
SYSTem:COMMunicate:RDEVice:GENerator<generator>:INTerface.................................. 882
SYSTem:COMMunicate:RDEVice:GENerator<generator>:LINK..........................................883
SYSTem:COMMunicate:RDEVice:GENerator<generator>:TYPE........................................ 884
SYSTem:COMMunicate:RDEVice:PMETer<p>:DEFine......................................................884
SYSTem:COMMunicate:RDEVice:PMETer<p>:CONFigure:AUTO[:STATe]......................... 885
SYSTem:COMMunicate:RDEVice:PMETer<p>:COUNt?.................................................... 885
SYSTem:COMMunicate:TCPip:RDEVice:GENerator<generator>:ADDRess.........................886
SYSTem:SPEaker:VOLume............................................................................................886
SYSTem:TIME:TSTamp?................................................................................................886
SYSTem:COMMunicate:GPIB:RDEVice:COMMand <GPIBAddress>, <Command>
.This command sends a command or query string to the external generator connected
via the GPIB interface.
This command is only available if the R&S FSVA/FSV option B10 (External Tracking
Generator) is installed.
Remote Control – Commands