Remote Control
R&S
®
FSVA/FSV
885Operating Manual 1176.7510.02 ─ 09
<SerialNo> Serial number of the power sensor assigned to the specified
index
Example:
SYST:COMM:RDEV:PMET2:DEF '','NRP-Z81','',
'123456'
Assigns the power sensor with the serial number '123456' to the
configuration "Power Sensor 2".
SYST:COMM:RDEV:PMET2:DEF?
Queries the sensor assigned to "Power Sensor 2".
Result:
'','NRP-Z81','USB','123456'
The NRP-Z81 power sensor with the serial number '123456' is
assigned to the "Power Sensor 2".
Mode: all
Manual operation: See "Power Sensor Assignment" on page 546
SYSTem:COMMunicate:RDEVice:PMETer<p>:CONFigure:AUTO[:STATe]
<State>
This command defines whether the selected power sensor index is automatically
assigned to a subsequently connected power sensor. See also "Power Sensor Assign-
ment" on page 546.
Suffix:
<p>
.
1...4
Power sensor index
Parameters:
<State> ON | OFF
*RST: ON
Example:
SYST:COMM:RDEV:PMET:CONF:AUTO OFF
Mode: ALL
Manual operation: See "Power Sensor Assignment" on page 546
SYSTem:COMMunicate:RDEVice:PMETer<p>:COUNt?
This command queries the number of power sensors currently connected to the
R&S FSVA/FSV.
Suffix:
<p>
.
1...4
irrelevant
Example:
SYST:COMM:RDEV:PMET:COUN?
Usage: Query only
Mode: ALL
Manual operation: See "Power Sensor Assignment" on page 546
Remote Control – Commands
To Next Page
Loading...
