Remote Control
R&S
®
FSVA/FSV
1002Operating Manual 1176.7510.02 ─ 09
Command Known Differences
RLPOS Adapts the position of the reference level even if the tracking generator normalization is
not active.
RQS Supported bits:
1 (Units key pressed)
2 (End of Sweep)
3 (Device error)
4 (Command complete)
5 (Illegal command)
SRCNORM Requires option R&S FSV-B9 or R&S FSV-B10
SRCPWR Requires option R&S FSV-B9 or R&S FSV-B10
SP Default value, range, step size
SS Default value, range, step size
ST Default value, range, step size
STB The status bits are mapped as described with command RQS.
Note: Bit 2 and 4 are always set in parallel if "Command Complete" or "End of Sweep" are
recognized. The R&S FSVA/FSV cannot distinguish between these conditions. Addition-
ally these bits are not suitable for synchronization on the end of sweep in continuous
sweep operation.
TA Output of 1001 trace points of trace A in O1 or O3 format.
TB Output of 1001 trace points of trace B in O1 or O3 format.
TH Default value
VB Range
VBR Default value
4.2.5.5 Model-Dependent Default Settings
If the GPIB language is switched over to an 85xx model, the GPIB address is automati-
cally switched over to 18 provided that the default address of the R&S FSVA/FSV (20)
is still set. If a different value is set, this value is maintained. Upon return to SCPI, this
address remains unchanged.
The following table shows the default settings obtained after a change of the GPIB lan-
guage and for the commands IP, KST and RESET:
Model # of Trace
Points
Start Freq. Stop Freq. Ref Level Input Coupling
8566A/B 1001 2 GHz 22 GHz 0 dBm AC
8568A/B 1001 0 Hz 1.5 GHz 0 dBm AC
8560E 601 0 Hz 2.9 GHz 0 dBm AC
8561E 601 0 Hz 6.5 GHz 0 dBm AC
Remote Control – Commands
To Next Page
Loading...
