Rohde & Schwarz FSVA - 2.2.4.4 Aligning the Touchscreen

Quick Start
R&S
®
FSVA/FSV
38Operating Manual 1176.7510.02 ─ 09
3. Press the "Time + Date" softkey to open the "Date and Time Properties" dialog
box.
The "Date & Time" tab is displayed.
Changing the date
1. Press the arrow on the "Month" field to display the list.
2. Select the month from the list.
3. Select the year by clicking on the up and down arrow buttons next to the "Year"
field.
4. Select the day in the calendar display or enter the date via the keyboard.
5. Click "OK".
Remote command
SYST:DATE 2008,10,1
Changing the time
You can change hours, minutes and seconds independently of each other.
1. Select the hour, minute or seconds area of the "Time" field.
2. Enter the required setting via the keyboard or rotary knob.
3. Repeat these steps until the hour, minute and second settings are correct.
4. Click "OK".
Remote command
SYST:TIME 12,30,30
Changing the time zone
1. Select the "Time Zone" tab.
2. Press the arrow on the "Time Zone" field to display the list.
3. Select the required time zone from the list.
4. Optionally, select the "Automatically adjust clock for daylight saving changes"
check box.
5. Click "OK".
2.2.4.4 Aligning the Touchscreen
When the device is delivered, the touchscreen is initially aligned. However, it may
become necessary to adjust the alignment later, e.g. after an image update or after
exchanging a hard disk. If you notice that touching a specific point on the screen does
not achieve the correct response, try adjusting the alignment.
Preparing for Use