Rohde & Schwarz FSVA - CALCulate:SGRam Subsystem

Remote Control
R&S
®
FSVA/FSV
732Operating Manual 1176.7510.02 ─ 09
CALCulate<n>:PEAKsearch|PSEarch:SUBRanges <NumberPeaks>
This command sets the number of peaks per range that are stored in the list. Once the
selected number of peaks has been reached, the peak search is stopped in the current
range and continued in the next range.
Suffix:
<n>
.
irrelevant
Parameters:
<NumberPeaks> 1 to 50
*RST: 25
Example:
CALC:PSE:SUBR 10
Sets 10 peaks per range to be stored in the list.
Manual operation: See "Peaks per Range" on page 382
CALCulate:SGRam Subsystem
These commands are only available if the "Spectrogram" measurements option
R&S FSV-K14 is installed.
CALCulate<n>:SGRam:CLEar[:IMMediate].......................................................................732
CALCulate<n>:SGRam:COLor........................................................................................ 732
CALCulate<n>:SGRam:CONT.........................................................................................733
CALCulate<n>:SGRam:FRAMe:COUNt........................................................................... 733
CALCulate<n>:SGRam:FRAMe:SELect........................................................................... 734
CALCulate<n>:SGRam:HDEPth......................................................................................734
CALCulate<n>:SGRam[:STATe]......................................................................................735
CALCulate<n>:SGRam:TSTamp[:STATe]........................................................................ 735
CALCulate<n>:SGRam:TSTamp:DATA?..........................................................................736
CALCulate<n>:SGRam:CLEar[:IMMediate]
This command resets the Spectrogram result display and clears the history buffer.
Suffix:
<n>
.
1...4
Selects the measurement window.
Example:
CALC:SGR:CLE
Resets the result display and clears the memory.
Usage: Event
Manual operation: See "Spectrogram Clear" on page 251
See "Clear Spectrogram" on page 556
CALCulate<n>:SGRam:COLor <Color>
This command selects the color scheme of the spectrogram result display.
Remote Control – Commands