Remote Control
R&S
®
FSVA/FSV
735Operating Manual 1176.7510.02 ─ 09
Parameters:
<HistoryDepth> The maximum number of frames depends on the number of
sweep points.
Range: 781 to 20000
Increment: 1
*RST: 3000
Example:
CALC:SGR:HDEP 1500
Sets the history depth to 1500.
Manual operation: See "Frame Count" on page 250
See "History Depth" on page 555
CALCulate<n>:SGRam[:STATe]
<State>
This command turns the spectrogram result display on and off.
Suffix:
<n>
.
1...4
Selects the measurement window.
Parameters:
<State> ON | OFF
*RST: OFF
Example:
CALC:SGR ON
Activates the Spectrogram result display.
Manual operation: See "Spectrogram (On Off)" on page 555
CALCulate<n>:SGRam:TSTamp[:STATe] <State>
This command activates and deactivates the time stamp.
If the time stamp is active, some commands do not address frames as numbers, but as
(relative) time values:
●
CALCulate<n>:DELTamarker<m>:SGRam:FRAMe on page 627
●
CALCulate<n>:MARKer<m>:SGRam:FRAMe on page 706
●
CALCulate<n>:SGRam:FRAMe:SELect on page 734
Suffix:
<n>
.
1...4
Selects the measurement window.
Parameters:
<State> ON | OFF
*RST: OFF
Example:
CALC:SGR:TST ON
Activates the time stamp.
Manual operation: See "Time Stamp (On Off)" on page 556
Remote Control – Commands
To Next Page
Loading...
