Rohde & Schwarz FSVA - SENSe:MIXer Subsystem

Remote Control
R&S
®
FSVA/FSV
822Operating Manual 1176.7510.02 ─ 09
Parameters:
<State> ON | OFF
*RST: ON
Example:
LIST:RANG3:SWE:TIME:AUTO OFF
Deactivates the sweep time auto mode for range 3.
Manual operation: See "Sweep Time Mode" on page 379
[SENSe:]LIST:RANGe<range>:TRANsducer <TransducerName>
This command sets a transducer for the specified range. You can only choose a trans-
ducer that fulfills the following conditions:
●
The transducer overlaps or equals the span of the range.
●
The x-axis is linear.
●
The unit is dB.
Suffix:
<range>
.
1...20
range
Parameters:
<TransducerName> 'string' = name of the transducer
Example:
SENS:LIST:RANG1:TRAN 'test'
Sets the transducer called "test" for range 1.
Manual operation: See "Transd. Factor" on page 380
SENSe:MIXer Subsystem
The MIXer subsystem controls the external mixer settings. These commands are only
available if the R&S FSV-B21 (Exeternal Mixer) option is installed.
[SENSe:]MIXer[:STATe]..................................................................................................823
[SENSe:]MIXer:BIAS:HIGH.............................................................................................823
[SENSe:]MIXer:BIAS:LOW..............................................................................................823
[SENSe:]MIXer:RFOVerrange[:STATe]............................................................................ 824
[SENSe:]MIXer:FREQuency:HANDover........................................................................... 824
[SENSe:]MIXer:FREQuency:STARt?................................................................................824
[SENSe:]MIXer:FREQuency:STOP?................................................................................ 825
[SENSe:]MIXer:HARMonic:BAND....................................................................................825
[SENSe:]MIXer:HARMonic:BAND:PRESet........................................................................825
[SENSe:]MIXer:HARMonic:HIGH:STATe..........................................................................826
[SENSe:]MIXer:HARMonic:HIGH[:VALue]........................................................................ 826
[SENSe:]MIXer:HARMonic[:LOW]....................................................................................826
[SENSe:]MIXer:HARMonic:TYPE.....................................................................................827
[SENSe:]MIXer:LOPower................................................................................................827
[SENSe:]MIXer:LOSS:HIGH............................................................................................827
[SENSe:]MIXer:LOSS:TABLe:HIGH.................................................................................827
[SENSe:]MIXer:LOSS:TABLe[:LOW]................................................................................828
[SENSe:]MIXer:LOSS[:LOW]...........................................................................................828
Remote Control – Commands