Rohde & Schwarz FSVA - Page 824

Remote Control
R&S
®
FSVA/FSV
824Operating Manual 1176.7510.02 ─ 09
Example:
MIX ON
Activates the external mixer.
MIX:BIAS:LOW 2A
Sets the bias for the low range to 2 A.
Mode: all
Manual operation: See "Bias Settings" on page 532
[SENSe:]MIXer:RFOVerrange[:STATe] <State>
This command specifies whether the frequencies beyond the defined band limits are to
be used.
This command is only available if the external mixer is active (see [SENSe:]MIXer[:
STATe] on page 823).
Parameters:
<State> ON | OFF
*RST: OFF
Example:
MIX:RFOV ON
Mode: all
Manual operation: See "RF Overrange" on page 526
[SENSe:]MIXer:FREQuency:HANDover <Frequency>
This command defines the frequency at which the mixer switches from one range to
the next (if two different ranges are selected). The handover frequency for each band
can be selected freely within the overlapping frequency range.
This command is only available if the external mixer is active (see [SENSe:]MIXer[:
STATe] on page 823).
Parameters:
<Frequency>
Example:
MIX ON
Activates the external mixer.
MIX:FREQ:HAND 78.0299GHz
Sets the handover frequency to 78.0299 GHz.
Mode: all
Manual operation: See "Handover Freq." on page 526
[SENSe:]MIXer:FREQuency:STARt?
This command queries the frequency at which the external mixer band starts.
Example:
MIX:FREQ:STAR?
Queries the start frequency of the band.
Remote Control – Commands