Quick Start
R&S
®
FSVA/FSV
23Operating Manual 1176.7510.02 ─ 09
The digital input and output can be enabled in the base unit or in one of the applica-
tions (where available).
2.2 Preparing for Use
2.2.1 Putting into Operation
This section describes the basic steps to be taken when setting up the R&S FSVA/FSV
for the first time.
Risk of injury and instrument damage
The instrument must be used in an appropriate manner to prevent electric shock, fire,
personal injury, or damage.
●
Do not open the instrument casing.
●
Read and observe the "Basic Safety Instructions" at the beginning of this manual,
in addition to the safety instructions in the following sections. Notice that the data
sheet may specify additional operating conditions.
Risk of instrument damage
Note that the general safety instructions also contain information on operating condi-
tions that prevent damage to the instrument. The instrument's data sheet can contain
additional operating conditions.
Risk of instrument damage during operation
An unsuitable operating site or test setup can damage the instrument and connected
devices. Ensure the following operating conditions before you switch on the instrument:
●
All fan openings are unobstructed and the airflow perforations are unimpeded. The
minimum distance from the wall is 10 cm.
●
The instrument is dry and shows no sign of condensation.
●
The instrument is positioned as described in the following sections.
●
The ambient temperature does not exceed the range specified in the data sheet.
●
Signal levels at the input connectors are all within the specified ranges.
●
Signal outputs are correctly connected and are not overloaded.
Preparing for Use
To Next Page
Loading...
