Quick Start
R&S
®
FSVA/FSV
34Operating Manual 1176.7510.02 ─ 09
2. Press the "Alignment" softkey.
3. Press the "Self Alignment" softkey.
Once the system correction values have been calculated successfully, a message
is displayed.
To display the alignment results again later
●
Press the SETUP key.
●
Press the "Alignment" softkey.
●
Press the "Show Align Results" softkey.
Performing a self test
The self test does not need to be repeated every time the instrument is switched on. It
is only necessary when instrument malfunction is suspected.
1. Press the SETUP key.
2. Press the "More" softkey.
3. Press the "Service" softkey.
4. Press the "Selftest" softkey.
Once the instrument modules have been checked successfully, a message is dis-
played.
2.2.1.10 Checking the Supplied Options
The instrument may be equipped with both hardware and firmware options. In order to
check whether the installed options correspond to the options indicated on the delivery
note, proceed as follows.
1. Press the SETUP key.
2. Press the "System Info" softkey.
3. Press the "Versions + Options" softkey.
A list with hardware and firmware information is displayed.
4. Check the availability of the hardware options as indicated in the delivery note.
For an overview of the available options, refer to the CD.
2.2.2 Connecting USB Devices
The USB interfaces of the R&S FSVA/FSV allow you to connect USB devices directly
to the instrument. This number can be increased as necessary by using USB hubs.
Due to the large number of available USB devices, there is almost no limit to the
expansions that are possible with the R&S FSVA/FSV.
Preparing for Use
To Next Page
Loading...
