Quick Start
R&S
®
FSVA/FSV
57Operating Manual 1176.7510.02 ─ 09
been established; a red symbol indicates that no LAN cable is connected. The
"Device Indicator" setting is not password-protected.
The navigation pane of the browser interface contains the following control elements:
●
"LAN Configuration" opens the LAN Configuration page.
●
"LXI Glossary" opens a document with a glossary of terms related to the LXI stan-
dard.
●
"Status" displays information about the LXI status of the instrument.
2.2.7.3 LAN Configuration
The "LAN Configuration" web page displays all mandatory LAN parameters and allows
their modification.
The "TCP/IP Mode" configuration field controls how the IP address for the instrument
gets assigned (see also Chapter 2.2.6.2, "Assigning the IP Address", on page 49). For
the manual configuration mode, the static IP address, subnet mask, and default gate-
way are used to configure the LAN. The automatic configuration mode uses DHCP
server or Dynamic Link Local Addressing (Automatic IP) to obtain the instrument IP
address.
Changing the LAN configuration is password-protected. The password is LxiWebIfc
(notice upper and lower case characters). This password cannot be changed in the
current firmware version.
The links at the bottom of the "LAN Configuration" page open other pages:
●
Advanced LAN Configuration provides LAN settings that are not declared manda-
tory by the LXI standard.
●
Ping provides the ping utility to verify the connection between the instrument and
other devices.
Advanced LAN Configuration
The "Advanced LAN Configuration" parameters are used as follows:
●
The "Negotiation" configuration field provides different Ethernet speed and duplex
mode settings. In general, the "Auto Detect" mode is sufficient.
●
"ICMP Ping" must be enabled to use the ping utility.
●
"VXI-11" is the protocol that is used to detect the instrument in the LAN. According
to the standard, LXI devices must use VXI-11 to provide a detection mechanism;
other additional detection mechanisms are permitted.
Ping
The instrument includes a ping server and a ping client. The ping client can be used to
verify the connection between instrument and another device. The ping command uses
Preparing for Use
To Next Page
Loading...
