Rohde & Schwarz FSVA - CALCulate:UNIT Subsystem; Other commands in the Calculate subsystem

Remote Control
R&S
®
FSVA/FSV
743Operating Manual 1176.7510.02 ─ 09
<Line> 1 | 2
Selects the time line.
Parameters:
<State> ON | OFF
*RST: OFF
Example:
CALC:TLIN2:STAT ON
Manual operation: See "Time Line 1 / Time Line 2" on page 420
CALCulate:UNIT Subsystem
The CALCulate:UNIT subsystem defines the units for the parameters that can be set
and the measurement results.
CALCulate<n>:UNIT:POWer <Unit>
This command selects the unit of the y-axis.
The unit applies to all measurement windows.
Suffix:
<n>
.
irrelevant
Parameters:
<Unit> DBM | V | A | W | DBPW | WATT | DBUV | DBMV | VOLT |
DBUA | AMPere
*RST: dBm
Example:
CALC:UNIT:POW DBM
Sets the power unit to dBm.
Manual operation: See "Unit" on page 228
Other commands in the Calculate subsystem
CALCulate<n>:FORMat <Format>
This command defines the display type of the IQ data.
Suffix:
<n>
.
irrelevant
Parameters:
<Format> RIMag
IQ data
MAGNitude
Magnitude
FREQuency
Spectrum
VECTor
IQ-Vector
Remote Control – Commands