Rohde & Schwarz FSVA - CALCulate:ESPectrum Subsystem

Remote Control
R&S
®
FSVA/FSV
634Operating Manual 1176.7510.02 ─ 09
Parameters:
<Position> The value range is variable.
The unit depends on CALCulate<n>:UNIT:POWer.
*RST: (state is OFF)
Example:
CALC:DLIN -20dBm
Manual operation: See "Display Line 1 / Display Line 2" on page 419
CALCulate<n>:DLINe<k>:STATe <State>
This command turns a display line on and off.
Suffix:
<n>
.
Selects the measurement window.
<k> 1 | 2
Selects the display line.
Parameters:
<State> ON | OFF
*RST: OFF
Example:
CALC:DLIN2:STAT OFF
Manual operation: See "Display Line 1 / Display Line 2" on page 419
CALCulate:ESPectrum Subsystem
The CALCulate:ESPectrum subsystem contains the remote commands for Spectrum
Emission Mask (SEM) measurements. Both groups of commands (PSEarch and
PEAKsearch) perform the same functions.
CALCulate<n>:ESPectrum:PSEarch|:PEAKsearch:[IMMediate].......................................... 634
CALCulate<n>:ESPectrum:PSEarch|:PEAKsearch:AUTO..................................................634
CALCulate<n>:ESPectrum:PSEarch|:PEAKsearch:MARGin...............................................635
CALCulate<n>:ESPectrum:PSEarch|:PEAKsearch:PSHow................................................ 635
CALCulate<n>:ESPectrum:PSEarch|:PEAKsearch:[IMMediate]
This command starts the list evaluation.
Suffix:
<n>
.
Selects the measurement window.
Example:
CALC:ESP:PSE
Usage: Event
CALCulate<n>:ESPectrum:PSEarch|:PEAKsearch:AUTO <State>
This command activates or deactivates the list evaluation.
Remote Control – Commands