Instrument Functions
R&S
®
FSVA/FSV
167Operating Manual 1176.7510.02 ─ 09
3 Instrument Functions
This chapter describes the analyzer functions and all basic settings functions of the
R&S FSVA/FSV in detail.
For each key the available softkey menus and commands are described. The com-
mands for the optional remote control (if any) are indicated for each softkey. The
description is divided into the following topics:
●
Chapter 3.1, "General Settings, Printout and Instrument Settings", on page 170
This section provides information on how to prepare measurements and process
their results: setting the instrument, managing and retrieving data, returning to
manual operation, and printout.
●
Chapter 3.2, "Measurement Parameters", on page 215
This section describes how to reset the instrument, to set up specific measure-
ments and to set the measurement parameters. Examples of basic operations are
provided in the Quick Start Guide, chapter 5 "Basic Measurement Examples".
Advanced examples are described in the Operating Manual on CD-ROM, chapter
"Advanced Measurement Examples".
●
Chapter 3.3, "Measurement Functions", on page 278
This section informs about how to select and configure the measurement functions.
Examples of basic operations are provided in the Quick Start Guide, chapter 5
"Basic Measurement Examples". Advanced examples are described in the Operat-
ing Manual on CD-ROM, chapter "Advanced Measurement Examples".
●
Chapter 3.4, "Measurement Modes", on page 435
This section describes the provided measurement modes, the change of measure-
ment modes and the access to the menus of all active measurement modes.
●
Chapter 3.6, "Instrument Functions – Tracking Generator (Options R&S FSV-B9/
R&S FSV-B10)", on page 474
This section provides information on how to configure and use optional tracking
generators (R&S FSVB9/B10).
●
Chapter 3.7, "Instrument Functions - R&S Digital I/Q Interface (Option R&S FSV-
B17)", on page 499
This section provides information on how to configure and use the optional R&S
Digital I/Q Interface for digital input and output (R&S FSVB17).
●
Chapter 3.8, "Instrument Functions – External Mixer (Option R&S FSV-B21)",
on page 517
●
This section provides information on how to configure and use optional external
mixers (R&S FSVB21).
●
Chapter 3.5, "Instrument Functions - I/Q Analyzer", on page 440
This section provides information on using the IQ Analyzer.
●
Chapter 3.9, "Instrument Functions - Power Sensor (R&S FSV-K9)", on page 538
This section describes how to configure and use an optional Power Sensor with an
R&S FSVA/FSV (option R&S FSV-K9).
●
Chapter 3.10, "Instrument Functions - Spectrogram Measurements", on page 551
This section describes how to perform Spectrogram measurements with an
R&S FSVA/FSV (option R&S FSV-K14).
To Next Page
Loading...
