Rohde & Schwarz FSVA - Page 168

Instrument Functions
R&S
®
FSVA/FSV
168Operating Manual 1176.7510.02 ─ 09
A brief introduction on handling the instrument is given in "Basic Operations" in the
Quick Start Guide. This also includes the description of the keys for basic operations
like switching the instrument on and off or starting a measurement.
The front and the rear view of the instrument together with a table of all available keys
and a short description are provided in the R&S FSVA/FSV Quick Start Guide. "Prepar-
ing for Use" informs how to start working with the instrument for the first time.
3.1 General Settings, Printout and Instrument Settings..............................................170
3.1.1 Instrument Setup and Interface Configuration – SETUP Key..................................... 170
3.1.2 Saving and Recalling Settings Files – SAVE/RCL Key...............................................196
3.1.3 Manual Operation – Local Menu.................................................................................210
3.1.4 Measurement Documentation – PRINT Key............................................................... 211
3.1.5 User-Defined Menu – USER key................................................................................ 213
3.2 Measurement Parameters........................................................................................ 215
3.2.1 Initializing the Configuration – PRESET Key.............................................................. 216
3.2.2 Selecting the Frequency and Span – FREQ Key........................................................218
3.2.3 Setting the Frequency Span – SPAN Key...................................................................223
3.2.4 Setting the Level Display and Configuring the RF Input – AMPT Key........................ 225
3.2.5 Defining Automatic Settings – AUTO SET Key...........................................................233
3.2.6 Setting the Bandwidths and Sweep Time – BW Key.................................................. 237
3.2.7 Configuring the Sweep Mode – SWEEP Key..............................................................246
3.2.8 Setting Traces – TRACE Key......................................................................................251
3.2.9 Triggering the Sweep – TRIG Key.............................................................................. 267
3.3 Measurement Functions...........................................................................................278
3.3.1 Using Markers and Delta Markers – MKR Key........................................................... 279
3.3.2 Performing Peak Searches with Markers – PEAK SEARCH Key............................... 286
3.3.3 Performing Marker Functions – MKR FUNC Key........................................................286
3.3.4 Changing Settings via Markers – MKR-> Key.............................................................300
3.3.5 Power Measurements – MEAS Key............................................................................310
3.3.6 Measurement Configuration – MEAS CONFIG Key................................................... 415
3.3.7 Using Limit Lines and Display Lines – LINES Key......................................................415
3.3.8 Input/Output Configuration – INPUT/OUTPUT Key.................................................... 427
3.3.9 Performing Measurements – RUN SINGLE/RUN CONT Keys...................................435
3.4 Measurement Modes.................................................................................................435
3.4.1 Measurement Mode Selection – MODE Key.............................................................. 435
3.4.2 Measurement Mode Menus – HOME Key.................................................................. 440