Remote Control
R&S
®
FSVA/FSV
1004Operating Manual 1176.7510.02 ─ 09
4.2.5.8 Trace Data Input Formats
Trace data input is only supported for binary date (TDF B, TDF A, TDF I, MDS W, MDS
B).
4.2.5.9 GPIB Status Reporting
The assignment of status bits by commands R1, R2, R3, R4, RQS is supported.
The STB command and the serial poll respond with an 8-bit value with the following
assignment:
Bit enabled by RQS Description
0 not used (value 0)
1 Units key pressed
2 End of Sweep
3 Device Error
4 Command Complete
5 Illegal Command
6 Service Request
7 not used (value 0)
Bits 0 and 7 are not used and always have the value 0.
Please note that the R&S FSVA/FSV reports any key pressed on the front panel rather
than only the unit keys if bit 1 was enabled.
Another difference is the behavior of bit 6 when using the STB? query. On the HP ana-
lyzers this bit monitors the state of the SRQ line on the bus. On the R&S FSVA/FSV
this is not possible. Therefore this bit is set, as soon as one of the bits 1 to 5 is set. It
won't be reset by performing a serial poll.
4.2.6 Reference: Command Set of Emulated PSA Models
The R&S FSVA/FSV analyzer family supports a subset of the GPIB commands of
PSA89600 and ESA instruments.
Despite the differences in system architecture and device features, the supported com-
mands have been implemented in a way to ensure a sufficiently high degree of corre-
spondence with the original.
In many cases the selection of commands supported by the R&S FSVA/FSV is suffi-
cient to run an existing GPIB program without adaptation.
Remote Control – Commands
To Next Page
Loading...
