Instrument Functions
R&S
®
FSVA/FSV
483Operating Manual 1176.7510.02 ─ 09
Generator Interface Type Generator Min
Freq
Generator Max
Freq
Generator Min
Power
dBm
Generator Max
Power
dBm
SMU06B31 TTL 100 kHz 6 GHz -145 +19
SMW20
TTL
4)
100 kHz 20 GHz -145 +30
SMW40
TTL
4)
100 kHz 40 GHz -145 +30
SMX GPIB 100 kHz 1.0 GHz -137 +13
SMY01 GPIB 9 kHz 1.04 GHz -140 +13
SMY02 GPIB 9 kHz 2.08 GHz -140 +13
HP8340A GPIB 10 MHz 26.5 GHz -110 10
HP8648 GPIB 9 kHz 4 GHz -136 10
HP ESG-A Ser-
ies 1000A,
2000A, 3000A,
4000A
GPIB 250 kHz 4 GHz -136 20
HP ESG-D
SERIES
E4432B
GPIB 250 kHz 3 GHz -136 +10
1) Requires the option SMR-B11 to be fitted.
2) Maximum/minimum power depends on presence of Option SMR-B15/-B17 and set frequency range. For
more details see SMR data sheet.
3) Maximum/minimum power depends on presence of Option SMP-B15/-B17 and set frequency range. For
more details see SMP data sheet.
4) Requires firmware version V3.20.200 or higher on the signal generator
3.6.3 Configuring Tracking Generators
The "Tracking Generator Configuration" dialog box is opened via the "Source Config"
softkey in the "Tracking Generator" menu.
This dialox box allows you to define measurement settings, as well as connection set-
tings for the optional external generators (option B10 only). Depending on which
options are installed, the corresponding tabs for internal or external generators, or
both, are displayed.
●
Chapter 3.6.3.1, "Internal Tracking Generator", on page 483
●
Chapter 3.6.3.2, "External Tracking Generator", on page 485
3.6.3.1 Internal Tracking Generator
The internal tracking generator is configured in the "Internal" tab of the "tracking Gen-
erator Configuration" dialog box.
In the top half of the dialog box, the measurement configurations can be defined. In the
lower half of the dialog box, the capabilities of the internal tracking generator are dis-
played for reference only.
Instrument Functions – Tracking Generator (Options R&S FSV-B9/ R&S FSV-B10)
To Next Page
Loading...
