Rohde & Schwarz FSVA - 4.3 Remote Control - Programming Examples

Remote Control
R&S
®
FSVA/FSV
1008Operating Manual 1176.7510.02 ─ 09
Supported 89600 commands
:SYSTem:TIME <hour>,<minute>,<second>
:SYSTem:VERSion?
:TRACe:COPY <src_trace>,<dest_trace>
:TRACe[:DATA] TRACE1 | TRACE2 | TRACE3 | TRACE4 | TRACE5 | TRACE6, <definite_length_block> |
<comma_separated_ASCII_data>
:TRACe:MODE WRITe|MAXHold|MINHold|VIEW|BLANk
:TRIGger[:SEQuence]:DELay <numeric>
:TRIGger[:SEQuence]:DELay:STATe OFF|ON|0|1
:TRIGger[:SEQuence]:EXTermal:DELay <numeric>
:TRIGger[:SEQuence]:EXTermal:LEVel <numeric>
:TRIGger[:SEQuence]:EXTermal:SLOPe POSitive|NEGative
:TRIGger[:SEQuence]:HOLDoff <numeric>
:TRIGger[:SEQuence]:IF:DELay <numeric>
:TRIGger[:SEQuence]:IF:LEVel <numeric>
:TRIGger[:SEQuence]:IF:SLOPe POSitive|NEGative
:TRIGger[:SEQuence]:SLOPe POSitive|NEGative
:TRIGger[:SEQuence]:SOURce IMMediate|VIDeo|EXTernal<1|2>
:TRIGger[:SEQuence]:VIDeo:LEVel <numeric>
:TRIGger[:SEQuence]:VIDeo:LEVel:FREQuency <freq>
4.3 Remote Control – Programming Examples
In this chapter, more complex programming examples are given. In the
R&S FSVA/FSV Quick Start Guide, basic steps in remote control programming are
provided.
The following programming examples have a hierarchical structure, i.e. subsequent
examples are based on previous ones. It is thus possible to compile an operational
program from the modules of the given examples very easily. VISUAL BASIC has been
used as programming language. However, the programs can be translated into other
languages.
In programming languages as C, C
++
or programs as MATLAB, NI Interactive Control,
a backslash starts an escape sequence (e.g. "\n" is used to start a new line). In these
programming languages and programs, two backslashes instead of one must be used
in remote commands (for an example refer to the R&S FSVA/FSV Quick Start Guide.)
Remote Control – Programming Examples