Rohde & Schwarz FSVA - 4.2.4.5 FORMat Subsytem; 4.2.4.6 HCOPy Subsystem

Remote Control
R&S
®
FSVA/FSV
930Operating Manual 1176.7510.02 ─ 09
4.2.4.5 FORMat Subsytem
The FORMat subsystem specifies the data format of the data transmitted from and to
the instrument.
FORMat[:DATA] <Format>
This command selects the data format for the data transmitted from the
R&S FSVA/FSV to the controlling computer. It is used for the transmission of trace
data. The data format of trace data received by the instrument is automatically recog-
nized, regardless of the format which is programmed.
In the "Spectrum" mode, the format setting REAL, 32 is used for the binary transmis-
sion of trace data.
(See also TRACe<n>[:DATA]? on page 887).
Parameters:
<Format> ASCii
ASCII data are transmitted in plain text, separated by commas.
REAL
REAL data are transmitted as 32-bit IEEE 754 floating-point
numbers in the "definite length block format".
*RST: ASCII
Example:
FORM REAL,32
FORM ASC
4.2.4.6 HCOPy Subsystem
The HCOPy subsystem controls the output of display information for documentation
purposes on output devices or files. The instrument allows two independent printer
configurations which can be set separately with the suffix <1|2>.
HCOPy:ABORt.............................................................................................................. 930
HCOPy:CMAP<item>:DEFault.........................................................................................931
HCOPy:CMAP<item>:HSL..............................................................................................931
HCOPy:CMAP<item>:PDEFined..................................................................................... 932
HCOPy:DESTination<1|2>..............................................................................................932
HCOPy:DEVice:COLor................................................................................................... 933
HCOPy:DEVice:LANGuage<1|2>.................................................................................... 933
HCOPy[:IMMediate<1|2>]............................................................................................... 934
HCOPy[:IMMediate<1|2>]:NEXT......................................................................................934
HCOPy:ITEM:ALL..........................................................................................................935
HCOPy:ITEM:WINDow:TABLe:STATe............................................................................. 935
HCOPy:ITEM:WINDow:TEXT..........................................................................................935
HCOPy:PAGE:ORIentation<1|2>.....................................................................................936
HCOPy:TDSTamp:STATe<1|2>...................................................................................... 936
HCOPy:ABORt
This command aborts a running hardcopy output.
Remote Control – Commands