Remote Control
R&S
®
FSVA/FSV
934Operating Manual 1176.7510.02 ─ 09
Parameters:
<Format> GDI
Graphics Device Interface:
Default format for the output to a printer configured under Win-
dows. Must be selected for the output to the printer interface.
Can be used for the output to a file. The printer driver configured
under Windows is used in this case and a printer-specific file for-
mat is thus generated.
(see also HCOPy:DESTination<1|2> command)
WMF | EWMF
WINDOWS Metafile and Enhanced Metafile Format:
Data formats for output files which can be integrated in corre-
sponding programs for documentation purposes at a later time.
WMF can only be used for output to a file and EWMF also for
the output to the clipboard.
(see also HCOPy:DESTination<1|2> command)
BMP | JPG | PNG
Data format for output to files only.
Example:
HCOP:DEV:LANG WMF
Usage: SCPI confirmed
Manual operation: See "Device Setup" on page 212
HCOPy[:IMMediate<1|2>]
This command initiates a print job.
If you are printing to a file, the file name depends on MMEMory:NAME.
The suffix <1|2> selects the printing device.
Example:
HCOP:DEV:LANG BMP
Selects the data format.
HCOP:DEST 'MMEM'
Directs the hardcopy to a file.
MMEM:NAME 'C:\R_S\instr\user\Print.bmp'
Selects the file name. If the file Print.bmp already exists, it is
replaced.
HCOP
Saves the hardcopy output into the file Print.bmp.
Usage: Event
SCPI confirmed
Manual operation: See "ScreenShot" on page 200
See "Print Screen" on page 211
HCOPy[:IMMediate<1|2>]:NEXT
This command initiates a print job.
Remote Control – Commands
To Next Page
Loading...
