Rohde & Schwarz FSVA - Page 823

Remote Control
R&S
®
FSVA/FSV
823Operating Manual 1176.7510.02 ─ 09
[SENSe:]MIXer:PORTs...................................................................................................828
[SENSe:]MIXer:SIGNal...................................................................................................829
[SENSe:]MIXer:THReshold............................................................................................. 829
[SENSe:]MIXer[:STATe] <State>
This command activates the external mixer.
Parameters:
<State> ON | OFF
*RST: OFF
Example:
MIX ON
Mode: all
Manual operation: See "External Mixer (On/Off)" on page 525
[SENSe:]MIXer:BIAS:HIGH
<BiasSetting>
This command defines the bias current for the high range (see also Chapter 3.8.1.2,
"Bias Current", on page 519).
This command is only available if the external mixer is active (see [SENSe:]MIXer[:
STATe] on page 823).
Parameters:
<BiasSetting> *RST: 0.0 A
Default unit: A
Example:
MIX ON
Activates the external mixer.
MIX:BIAS:HIGH 2A
Sets the bias for the high range to 2 A.
Mode: all
Manual operation: See "Bias Settings" on page 532
[SENSe:]MIXer:BIAS:LOW <BiasSetting>
This command defines the bias current for the low range (see also Chapter 3.8.1.2,
"Bias Current", on page 519).
This command is only available if the external mixer is active (see [SENSe:]MIXer[:
STATe] on page 823).
Parameters:
<BiasSetting> *RST: 0.0 A
Default unit: A
Remote Control – Commands