Remote Control
R&S
®
FSVA/FSV
731Operating Manual 1176.7510.02 ─ 09
Example:
CALC:PSE
Starts to determine the list.
CALCulate<n>:PEAKsearch|PSEarch:AUTO <State>
This command activates or deactivates the list evaluation.
Suffix:
<n>
.
Selects the measurement window.
Parameters:
<State> ON | OFF
*RST: ON
Example:
CALC:ESP:PSE:AUTO OFF
Deactivates the list evaluation.
Manual operation: See "List Evaluation (On/Off)" on page 352
See "List Evaluation (On/Off)" on page 382
CALCulate<n>:PEAKsearch|PSEarch:MARGin <Margin>
This command sets the margin used for the limit check/peak search.
Suffix:
<n>
.
Selects the measurement window.
Parameters:
<Margin> -200 to 200 dB
*RST: 200 dB
Example:
CALC:ESP:PSE:MARG 100
Sets the margin to 100 dB.
Manual operation: See "Margin" on page 352
See "Margin" on page 382
CALCulate<n>:PEAKsearch|PSEarch:PSHow
This command marks all peaks with blue squares in the diagram.
Suffix:
<n>
.
Selects the measurement window.
Parameters:
<State> ON | OFF
*RST: OFF
Example:
CALC:ESP:PSE:PSH ON
Marks all peaks with blue squares.
Manual operation: See "Show Peaks" on page 382
Remote Control – Commands
To Next Page
Loading...
