Remote Control
R&S
®
FSVA/FSV
880Operating Manual 1176.7510.02 ─ 09
Usage: SCPI confirmed
Mode: all
STATus:QUEStionable:POWer:PTRansition <BitDefinition>
This command sets the edge detectors of all bits of the
STATus:QUEStionable:POWer register from 0 to 1 for the transitions of the "CONDi-
tion" bit.
Parameters:
<BitDefinition> 0 to 65535
Example:
STAT:QUES:POW:PTR 65535
Usage: SCPI confirmed
Mode: all
STATus:QUEStionable:SYNC[:EVENt]?
This command queries the contents of the "EVENt" part of the
STATus:QUEStionable:SYNC register. For details see the description for the individ-
ual firmware applications.
Readout deletes the contents of the "EVENt" part.
Example:
STAT:QUES:SYNC?
Usage: Query only
Mode: This command is required by the firmware applications only.
STATus:QUEStionable:SYNC:CONDition?
This command queries the contents of the "CONDition" part of the
STATus:QUEStionable:SYNC register. For details see the description for the individ-
ual firmware applications.
Readout does not delete the contents of the "CONDition" part.
Example:
STAT:QUES:SYNC:COND?
Usage: Query only
Mode: This command is required by the firmware applications only.
STATus:QUEStionable:SYNC:ENABle <BitDefinition>
This command sets the bits of the "ENABle" part of the
STATus:QUEStionable:SYNC register. The "ENABle" register selectively enables
the individual events of the associated "EVENt" part for the summary bit.
Parameters:
<BitDefinition> 0 to 65535
Remote Control – Commands
To Next Page
Loading...
