Rohde & Schwarz FSVA - Page 657

Remote Control
R&S
®
FSVA/FSV
657Operating Manual 1176.7510.02 ─ 09
Example:
CALC:LIM2:LOW -30,-40,-10,-40,-30
Defines 5 lower limit values for limit line 2 in the preset unit.
CALC:LIM2:LOW?
Outputs the lower limit values of limit line 2 separated by a
comma.
Manual operation: See "Edit Value" on page 418
CALCulate<n>:LIMit<k>:LOWer:MARGin <Margin>
This command defines an area around a lower limit line where limit check violations
are still tolerated.
Suffix:
<n>
.
irrelevant
<k> 1...8
Selects the limit line.
Parameters:
<Margin> Numeric value that defines the margin.
In spectrum mode, the unit is always dB.
*RST: 0
Example:
CALC:LIM:LOW:MARG 10dB
CALCulate<n>:LIMit<k>:LOWer:MODE <Mode>
This command selects the vertical limit line scaling.
Suffix:
<n>
.
irrelevant
<k> 1...8
Selects the limit line.
Parameters:
<Mode> ABSolute
Limit line is defined by absolute physical values. The unit is vari-
able.
RELative
Limit line is defined by values relative to the reference level (dB).
*RST: ABSolute
Example:
CALC:LIM:LOW:MODE REL
Defines the y-axis of limit line 2 as relative scaled.
Manual operation: See "Edit Name" on page 417
CALCulate<n>:LIMit<k>:LOWer:OFFSet <Offset>
This command defines an offset for a complete lower limit line.
Remote Control – Commands