Remote Control
R&S
®
FSVA/FSV
639Operating Manual 1176.7510.02 ─ 09
Return values:
<Result> 0
PASS
1
FAIL
Example:
INIT;*WAI
Starts a new sweep and waits for its end.
CALC:LIM3:FAIL?
Queries the result of the check for limit line 3.
Usage: Query only
Manual operation: See "Limit Check 1-4" on page 349
See "Limit Check 1-4" on page 380
For option WLAN TX Measurements, R&S FSV-K91/91n, the numeric suffix <k> speci-
fies the limit lines as follows:
Suffix Limit
1 to 2 These indexes are not used
3 ETSI Spectrum Mask limit line
4 Spectrum Flatness (Upper) limit line
5 Spectrum Flatness (Lower) limit line
6 IEEE Spectrum Mask limit line
7 PVT Rising Edge max limit
8 PVT Rising Edge mean limit
9 PVT Falling Edge max limit
10 PVT Falling Edge mean limit
CALCulate<n>:LIMit<k>:NAME <Name>
This command selects a limit line that already exists or defines a name for a new limit
line.
Suffix:
<n>
.
irrelevant
<k> 1...8 (NF: 1...6)
Selects the limit line.
Parameters:
<Name> String containing the limit line name.
*RST: REM1 to REM8 for lines 1 to 8
Example:
CALC:LIM1:NAME 'FM1'
Assigns the name FM1 to limit line 1.
Remote Control – Commands
To Next Page
Loading...
