Rohde & Schwarz FSVA - Page 700

Remote Control
R&S
®
FSVA/FSV
700Operating Manual 1176.7510.02 ─ 09
Return values:
<Standard> <Predefined standard> | USER | NONE
<Predefined standard>
Predefind standard according to table in "Predefined CP/ACLR
Standards" on page 711.
USER
User-defined standard is set
NONE
not yet defined
with <string> being the name of a user standard. Note that pre-
defined standards go without quotes, while user standards have
to be in quotes ('user standard').
For further details refer to "Predefined CP/ACLR Standards"
on page 711.
Example:
CALC:MARK:FUNC:POW:PRES TETRA
Selects the standard setting for TETRA
Example:
CALC:MARK:FUNC:POW:PRES 'my_aclr_standard'
Selects the user standard my_aclr_standard
Manual operation: See "CP/ACLR Standard" on page 325
See "Load" on page 333
CALCulate<n>:MARKer<m>:FUNCtion:POWer:RESult? <ResultType>
This command queries the result of the performed power measurement in the window
specified by the suffix <n>. If necessary, the measurement is switched on prior to the
query.
The channel spacings and channel bandwidths are configured in the SENSe:POWer
subsystem.
To obtain a correct result, a complete sweep with synchronization to the end of the
sweep must be performed before a query is output. Synchronization is possible only in
the single sweep mode.
Suffix:
<n>
.
Selects the measurement window.
<m> Selects the marker.
Remote Control – Commands