Rohde & Schwarz FSVA - Page 703

Remote Control
R&S
®
FSVA/FSV
703Operating Manual 1176.7510.02 ─ 09
CALCulate<n>:MARKer<m>:FUNCtion:POWer:RESult:PHZ <State>
This command switches the query response of the power measurement results
between output of absolute values and output referred to the measurement bandwith.
The measurement results are output with the CALCulate<n>:MARKer<m>:
FUNCtion:POWer:RESult? command.
Suffix:
<n>
.
Selects the measurement window.
<m> Selects the marker.
Parameters:
<State> ON | OFF
ON
Results output: channel power density in dBm/Hz
OFF
Results output: channel power is displayed in dBm
*RST: OFF
Example:
CALC:MARK:FUNC:POW:RES:PHZ ON
Output of results referred to the channel bandwidth.
For details on a complete measurement example refer to
CALCulate<n>:MARKer<m>:FUNCtion:POWer:RESult?
on page 700.
Manual operation: See "Chan Pwr/Hz" on page 330
CALCulate<n>:MARKer<m>:FUNCtion:POWer:SELect <MeasType>
This command selects – and switches on – the specified power measurement type in
the window specified by the suffix <n>.
The channel spacings and channel bandwidths are configured in the SENSe:POWer
subsystem.
Note: If CPOWer is selected, the number of adjacent channels ( [SENSe:]POWer:
ACHannel:ACPairs) is set to 0. If ACPower is selected, the number of adjacent
channels is set to 1, unless adjacent-channel power measurement is switched on
already.
The channel/adjacent-channel power measurement is performed for the trace selected
with [SENSe:]POWer:TRACe.
The occupied bandwidth measurement is performed for the trace on which marker 1 is
positioned. To select another trace for the measurement, marker 1 is to be positioned
on the desired trace by means of CALCulate<n>:MARKer<m>:TRACe.
Suffix:
<n>
.
Selects the measurement window.
<m> Selects the marker.
Remote Control – Commands