Instrument Function
R&S
®
SMBV100A
119Operating Manual 1407.6062.32 ─ 08
How to connect the signal generator to the network is described in chapter 2.6.1, "Con-
necting the Instrument to the Network", on page 39.
Risk of network errors!
Connecting errors may affect the entire network.
We recommend to coordinate the connection of the instrument to the network with the
network administrator.
Do not connect or disconnect the network cable until the instrument is switched off
(standby). Only then the network connection can be reliably detected and impairments
to instrument operation can be avoided.
The dialog provides an access to the network settings, like settings about the general
network environment and specific identification of the computer in the network, as well
as an indication whether the instrument is connected to the network or not.
Network Status
Indicates whether the instrument is connected to the network or not.
SCPI command:
n.a.
Hostname
Enters the individual computer name of the R&S Signal Generator.
Note: The computer name can only be changed after protection level 1 is deactivated
(see chapter 5.2.3.15, "Protection", on page 127).
A predefined name is indicated and can be used for network connections.
SCPI command:
:SYSTem:COMMunicate:NETWork[:COMMon]:HOSTname on page 708
Workgroup
Enters the individual windows workgroup name of the R&S Signal Generator. This
parameter is necessary in case the instrument is integrated in a windows network.
General Instrument Settings
To Next Page
Loading...
