Instrument Function
R&S
®
SMBV100A
130Operating Manual 1407.6062.32 ─ 08
Confirm Password (Security Password)
Enters the new password for conformation.
The new password is only valid after the "Change Password" button is pressed.
SCPI command:
n.a.
Change Password (Security Password)
Changes the password accordingly.
SCPI command:
n.a.
USB Device
Enables/disables the USB interfaces.
The instrument does not recognize any device connected to the USB interface when the
interface is disabled.
The setting requires the entry of the security password and is only accepted after the
"Accept" button is pressed.
SCPI command:
n.a.
LAN Connection
Enables/disables the LAN interface.
It is not possible to access the instrument via LAN while the LAN connection is disabled.
The setting requires the entry of the security password and is only accepted after the
"Accept" button is pressed.
SCPI command:
n.a.
Annotation Frequency
Enables/disables the display of the currently used frequency in the header of the instru-
ment.
The setting requires the entry of the security password and is only accepted after the
"Accept" button is pressed.
SCPI command:
:DISPlay:ANNotation:FREQuency on page 462
Annotation Amplitude
Enables/disables the display of the currently selected level in the header of the instru-
ment.
The setting requires the entry of the security password and is only accepted after the
"Accept" button is pressed.
SCPI command:
:DISPlay:ANNotation:AMPLitude on page 461
Display
Enables/disables the display.
General Instrument Settings
To Next Page
Loading...
