Instrument Function
R&S
®
SMBV100A
184Operating Manual 1407.6062.32 ─ 08
"Edit"
Calls a selection of possible actions described below.
"Insert Row"
Insert a new row before the marked row.
"Insert Range"
Insert new rows before the marked row. The number of rows to be
inserted can be defined in an entry window.
"Fill...."
Opens a sub menu for defining a set of list values to be automatically
entered in the ucor list (see chapter 5.4.10.2, "Filling the Correction List
automatically", on page 186).
"Fill With Sen-
sor"
Calls the menu to activate the filling of the user correction list with level
values acquired by the selected power sensor (see chapter 5.4.10.3,
"Filling the Correction List with Power Sensor Measurement
Data", on page 187).
"Delete Row"
Deletes the marked row.
"Delete
Range..."
Allows to delete any number of rows starting with the marked row. The
number of rows to be deleted can be defined in an entry window.
"Save as"
Open the file menu to save the list under a new name.
Note: Save list only after filling both columns (frequency and level),
otherwise the entries are lost.
Each list is saved to the R&S Signal Generator hard disk as a separate
file with the file prefix *.uco. The file name and the directory to which
the file is saved are user-selectable.
"Save"
The list is saved under its current name.
SCPI command:
[:SOURce<hw>]:CORRection:CSET[:SELect] on page 622
[:SOURce<hw>]:CORRection:CSET:DATA:FREQuency on page 617
[:SOURce<hw>]:CORRection:CSET:DATA:POWer on page 617
Import/Export
User correction list can be imported from externally created files or exported into text or
CSV-files. The import/export settings are available after clicking the "Import/Export" but-
ton.
RF Signal and Analog Modulations - RF Block
To Next Page
Loading...
