Instrument Function
R&S
®
SMBV100A
314Operating Manual 1407.6062.32 ─ 08
SCPI command:
[:SOURce<hw>]:BB:DM:PRAMp:RDELay on page 570
Fall Delay - Power Ramp Control - Digital Modulation
Sets the offset in the falling edge of the envelope at the end of a burst.
A positive value gives rise to a delay, the envelope length increases and a negative value
causes an advance (the envelope length decreases). The setting is expressed in sym-
bols.
SCPI command:
[:SOURce<hw>]:BB:DM:PRAMp:FDELay on page 570
Attenuation - Power Ramp Control - Digital Modulation
Sets the level attenuation relative to the average level for the signal ranges in which the
level is set to "attenuated" (LEV_ATT control signal).
The LEV_ATT control signal is defined in the "Control Data Editor".
SCPI command:
[:SOURce<hw>]:BB:DM:PRAMp:ATTenuation on page 569
Baseband Only - Power Ramp Control - Digital Modulation
Restricts power ramping to the baseband signal.
Baseband Signal - Baseband Block
To Next Page
Loading...
