Instrument Function
R&S
®
SMBV100A
329Operating Manual 1407.6062.32 ─ 08
SCPI command:
[:SOURce<hw>]:BB:ARB:WAVeform:SELect on page 538
Waveform Info
Opens a dialog with detailed information about the currently selected waveform.
The waveform information displayed in this dialog depends on whether the selected
waveform file is a multi segment one or not. All parameters are read-only.
For non-multi segment waveform files, the values of the settings can be queried by means
of the Tag commands (see chapter 7.3, "R&S Signal Generator Waveform and List For-
mat", on page 439).
SCPI command:
n.a.
Clock Frequency
Displays or enters the ARB output clock rate.
When the waveform file is loaded, this value is automatically set to the clock rate defined
in the file (Clock tag). The user can subsequently alter the value if necessary.
Baseband Signal - Baseband Block
To Next Page
Loading...
