Instrument Function
R&S
®
SMBV100A
328Operating Manual 1407.6062.32 ─ 08
Switching on this standard turns off all the other digital standards and digital modulation
types.
The output is based on the waveform file that is loaded. The name of the waveform file
is displayed next to "Load Waveform".
If a multi segment waveform is loaded the section "Multi Segment Waveform Options" is
indicated. In this section, the segment to be output is selected.
If no waveform file is loaded, ARB modulation cannot be powered up. "None" will be
displayed next to "Load Waveform". An error message asks the user to load a waveform
file:
"No waveform file loaded. ARB MOD state remains off. Please select a waveform file to
load, before switching ARB MOD state on."
SCPI command:
[:SOURce<hw>]:BB:ARB:STATe on page 505
Set To Default
Calls default settings. The values are shown in the table 5-10.
Table 5-10: Default Settings
Parameter Value
State Off
Clock Freq. 1 MHz
Trigger Mode Auto
Trigger Source Internal
Marker State Off
Marker Mode Unchanged
Clock Source Internal
SCPI command:
[:SOURce<hw>]:BB:ARB:PRESet on page 505
Load Waveform
Calls the "File Select "menu for loading the waveform file.
The files last used are listed in the "Recent Data Sets" section. The directory can be
selected from the center left section. All waveform files (file extension *.wv) available
from the selected directory are listed on the right side. The file info (tag contents and multi
segment state) for the selected file is displayed below the file section.
The "Select..." button selects the marked file. This file is loaded when the ARB modulation
is enabled ("State On").
The "File Manager..." button leads to the file manager.
Baseband Signal - Baseband Block
To Next Page
Loading...
