Rohde & Schwarz SMBV100A - Page 383

Instrument Function
R&S
®
SMBV100A
366Operating Manual 1407.6062.32 ─ 08
Carrier Table Assistant
Number of Carriers
Defines the number of carriers of the multi carrier waveform.
This parameter is identical to that in the "General Setting" section.
SCPI command:
[:SOURce<hw>]:BB:ARB:MCARrier:CARRier:COUNt on page 522
Carrier State
Switches the carriers in the range "Carrier Start" to "Carrier Stop" on/off.
SCPI command:
[:SOURce<hw>]:BB:ARB:MCARrier:EDIT:CARRier:STATe on page 532
Carrier Start
Defines the start index of the carrier range to which the assistant settings are intended
to apply.
SCPI command:
[:SOURce<hw>]:BB:ARB:MCARrier:EDIT:CARRier:STARt on page 531
Carrier Stop
Defines the stop index of the carrier range to which the assistant settings are intended
to apply.
SCPI command:
[:SOURce<hw>]:BB:ARB:MCARrier:EDIT:CARRier:STOP on page 531
Gain Start
Sets the gain of the carrier marked by "Carrier Start".
SCPI command:
[:SOURce<hw>]:BB:ARB:MCARrier:EDIT:CARRier:POWer[:STARt]
on page 531
Gain Step
Sets the step width that is used to increment the gain
Baseband Signal - Baseband Block