Rohde & Schwarz SMBV100A - Page 384

Instrument Function
R&S
®
SMBV100A
367Operating Manual 1407.6062.32 ─ 08
The resulting carrier gain in the carrier table equals:
GainStart + n* Gain Step
where n ranges from 0 to (Carrier Stop - Carrier Start).
SCPI command:
[:SOURce<hw>]:BB:ARB:MCARrier:EDIT:CARRier:POWer:STEP on page 531
Phase Start
Sets the phase of the carrier marked by "Carrier Start".
SCPI command:
[:SOURce<hw>]:BB:ARB:MCARrier:EDIT:CARRier:PHASe[:STARt]
on page 530
Phase Step
Sets the step width that is used to increment the phase.
The resulting phase in the carrier table equals:
PhaseStart + n* PhaseStep
where n ranges from 0 to (Carrier Stop – Carrier Start)
SCPI command:
[:SOURce<hw>]:BB:ARB:MCARrier:EDIT:CARRier:POWer:STEP on page 531
Delay Start
Sets the delay of the carrier marked by "Carrier Start".
SCPI command:
[:SOURce<hw>]:BB:ARB:MCARrier:EDIT:CARRier:DELay[:STARt]
on page 529
Delay Step
Sets the step width that is used to increment the delay
The resulting delay in the carrier table equals:
DelayStart + n* DelayStep
where n ranges from 0 to (Carrier Stop – Carrier Start).
SCPI command:
[:SOURce<hw>]:BB:ARB:MCARrier:EDIT:CARRier:DELay:STEP on page 528
Input Waveform File
Calls the "File" menu for selecting the inputfile with the I/Q signal to be modulated onto
all carriers of the selected carrier range.
SCPI command:
[:SOURce<hw>]:BB:ARB:MCARrier:EDIT:CARRier:FILE on page 530
Apply Assistant Settings
Transfer the assistant settings to the carrier table.
SCPI command:
[:SOURce<hw>]:BB:ARB:MCARrier:EDIT:CARRier:EXECute on page 529
Baseband Signal - Baseband Block