Instrument Function
R&S
®
SMBV100A
368Operating Manual 1407.6062.32 ─ 08
Carrier Table
The table displays the settings of all available carriers. Previously applied assistant set-
tings can be further refined. The number of lines corresponds to the number of carriers.
Note: The phase/deg settings are only valid if optimization of the crest factor is disabled
("Crest Factor Mode" = Off).
No ← Carrier Table
Indicates the carrier index ranging from 0 to (number of carriers -1).
Individual carriers can be set using the remote control commands by specifying the index
in the parameter CARR.
State ← Carrier Table
Switches On/Off a carrier.
SCPI command:
[:SOURce<hw>]:BB:ARB:MCARrier:CARRier<ch>:STATe on page 525
Carrier Freq [MHz] ← Carrier Table
Sets the carrier frequency.
Note: The carrier frequnecy can only be set in "Arbitrary Carrier frequency" mode.
For "Equidistant Carrier Spacing", the carrier spacing is determined automatically.
SCPI command:
[:SOURce<hw>]:BB:ARB:MCARrier:CARRier<ch>:FREQuency on page 524
Gain ← Carrier Table
Sets the gain of a carrier.
SCPI command:
[:SOURce<hw>]:BB:ARB:MCARrier:CARRier<ch>:POWer on page 525
Phase ← Carrier Table
Sets the starting phase of a carrier.
SCPI command:
[:SOURce<hw>]:BB:ARB:MCARrier:CARRier<ch>:PHASe on page 525
Delay ← Carrier Table
Sets the starting delay of a carrier.
SCPI command:
[:SOURce<hw>]:BB:ARB:MCARrier:CARRier<ch>:DELay on page 524
Baseband Signal - Baseband Block
To Next Page
Loading...
