Instrument Function
R&S
®
SMBV100A
377Operating Manual 1407.6062.32 ─ 08
Trigger/Marker
Calls the "Trigger/Marker" dialog (see "Trigger/Marker/Clock Settings" on page 377).
This dialog is used to select the trigger source, set the time delay on an external trigger
signal and configure the marker output signals.
SCPI command:
n.a.
Clock
Calls the "Clock" dialog for selecting the clock source (see "Clock Set-
tings" on page 383).
SCPI command:
n.a.
Trigger/Marker/Clock Settings
To access this dialog, select "Main Menu > Trigger/Marker".
The "Trigger In" section is where the trigger for the signal is set. Various parameters will
be provided for the settings, depending on which trigger source - internal or external - is
selected. The current status of signal generation ("Running" or "Stopped") is indicated
for all trigger modes.
The "Marker Mode" section is where the marker signals at the MARKER output connec-
tors are configured.
The "Marker Delay" section is where a marker signal delay can be defined, either without
restriction or restricted to the dynamic section, i.e., the section in which it is possible to
make settings without restarting signal and marker generation.
Baseband Signal - Baseband Block
To Next Page
Loading...
