Instrument Function
R&S
®
SMBV100A
383Operating Manual 1407.6062.32 ─ 08
The delay can be defined by moving the setting mark.
SCPI command:
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:DELay:MINimum on page 605
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:DELay:MAXimum on page 604
Fix marker delay to current range
Restricts the marker delay setting range to the dynamic range. In this range the delay
can be set without restarting the marker and signal.
SCPI command:
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut:DELay:FIXed on page 604
Clock Settings
The Clock Settings is used to set the clock source and a delay if required.
Sync. Mode
Selects the synchronization mode.
This parameter is used to enable generation of very precise synchronous signal of several
connected R&S SMBVs.
Note: If several instruments are connected, the connecting cables from the master
instrument to the slave one and between each two consecutive slave instruments must
have the same length and type.
Avoid unnecessary cable length and branching points.
"None"
The instrument is working in stand-alone mode.
"Sync. Master"
The instrument provides all connected instrument with its synchronisa-
tion (including the trigger signal) and reference clock signal.
"Sync. Slave"
The instrument receives the synchronisation and reference clock signal
from another instrument working in a master mode.
SCPI command:
[:SOURce<hw>]:BB:MCCW:CLOCk:SYNChronization:MODE on page 609
Set Synchronization Settings
Performs automatically adjustment of the instrument's settings required for the synchro-
nization mode, selected with the parameter "Synchronization Mode".
SCPI command:
[:SOURce<hw>]:BB:MCCW:CLOCk:SYNChronization:EXECute on page 610
Clock Source
Selects the clock source.
"Internal"
The internal clock reference is used to generate the symbol clock.
Baseband Signal - Baseband Block
To Next Page
Loading...
