Rohde & Schwarz SMBV100A - Page 621

Remote Control Commands
R&S
®
SMBV100A
604Operating Manual 1407.6062.32 ─ 08
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:DELay.................................................604
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:DELay:MAXimum.................................604
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:DELay:MINimum..................................605
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:MODE.................................................605
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:OFFTime.............................................606
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:ONTime..............................................606
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:PATTern.............................................606
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:PULSe:DIVider....................................607
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:PULSe:FREQuency.............................607
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut:DELay:FIXed <Fixed>
The command restricts the marker delay setting range to the dynamic range. In this range
the delay can be set without restarting the marker and signal. If a delay is entered in
setting ON but is outside this range, the maximum possible delay is set and an error
message is generated.
The numeric suffix in OUTPut has no significance for this command, since the setting
always affects every marker.
Parameters:
<Fixed> 0 | 1 | OFF | ON
*RST: 0
Example:
BB:MCCW:TRIG:OUTP:DEL:FIX ON
restricts the marker signal delay setting range to the dynamic
range.
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:DELay <Delay>
The command defines the delay between the signal on the marker outputs and the start
of the signals, expressed in terms of samples. Com-
mand :BB:MCCW:TRIGger:OUTPut:DELay:FIXed ON can be used to restrict the
range of values to the dynamic range, i.e. the range within which a delay of the marker
signals can be set without restarting the marker and signal.
Parameters:
<Delay> float
Range: 0 to 2^20-1 symbols
Increment: 1E-3
*RST: 0 symbols
Example:
BB:MCCW:TRIG:OUTP2:DEL 16
sets a delay of 16 samples for the signal on connector MARKER
2.
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:DELay:MAXimum?
The command queries the maximum marker delay for set-
ting :BB:MCCW:TRIGger:OUTPut: DELay:FIXed ON.
SOURce Subsystem