Rohde & Schwarz SMBV100A - Page 580

Remote Control Commands
R&S
®
SMBV100A
563Operating Manual 1407.6062.32 ─ 08
Return values:
<Frequency> float
Example:
BB:DM:TRIG:OUTP2:PULS:DIV 2
sets the divider marker signal on output MARKER 2 to the value
2.
BB:DM:TRIG:OUTP2:MODE PULS
enables the pulsed marker signal.
BB:DM:TRIG:OUTP2:PULS:FREQ?
queries the pulse frequency of the marker signal.
Response: 33 000
the resulting pulse frequency is
Usage: Query only
Filter Settings
[:SOURce<hw>]:BB:DM:FILTer:OSAMpling......................................................................563
[:SOURce<hw>]:BB:DM:FILTer:OSAMpling:AUTO............................................................563
[:SOURce<hw>]:BB:DM:FILTer:PARameter:COSine[:ROLLoff]...........................................564
[:SOURce<hw>]:BB:DM:FILTer:PARameter:GAUSs..........................................................564
[:SOURce<hw>]:BB:DM:FILTer:PARameter:LPASs...........................................................564
[:SOURce<hw>]:BB:DM:FILTer:PARameter:LPASSEVM...................................................564
[:SOURce<hw>]:BB:DM:FILTer:PARameter:PGAuss.........................................................564
[:SOURce<hw>]:BB:DM:FILTer:PARameter:RCOSine.......................................................564
[:SOURce<hw>]:BB:DM:FILTer:PARameter:SPHase.........................................................564
[:SOURce<hw>]:BB:DM:FILTer:PARameter:APCO25........................................................564
[:SOURce<hw>]:BB:DM:FILTer:PARameter:COSine:BANDwidth........................................565
[:SOURce<hw>]:BB:DM:FILTer:PARameter:APCO25Lsm:GAUSs......................................565
[:SOURce<hw>]:BB:DM:FILTer:PARameter:APCO25Lsm:LOWPass..................................565
[:SOURce<hw>]:BB:DM:FILTer:TYPE..............................................................................565
[:SOURce<hw>]:BB:DM:FILTer:OSAMpling <OSampling>
The command sets the upsampling factor.
Parameters:
<OSampling> integer
Range: 1 to 32
Increment: 1
*RST: 32
Example:
BB:DM:FILT:OSAM 32
sets the upsampling factor to 32.
[:SOURce<hw>]:BB:DM:FILTer:OSAMpling:AUTO <Auto>
The command activates/deactivates the upsampling factor state. If activated, the most
sensible parameter values are selected. The value depends on the coherence check. If
deactivated, the values can be changed manually.
SOURce Subsystem