EasyManua.ls Logo

Schweitzer Engineering SEL-2032 - Page 198

Schweitzer Engineering SEL-2032
354 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10
SEL-2032 Communications Processor Instruction Manual Date Code 20120126
Settings Sheets
SEL-2701, SET P, and SET A
Date: ________________________________
Approved by: _________________________
SEL-2032 S/N: _______________________
SEL-2701, SET P, and SET A
Port ( 17 / 18 )
SET P
SENDTIME Send Date/Time synchronization to Protocol Card (Y/N) ____________________
XON_XOFF Enable XON/XOFF flow control (Y/N ____________________
TIMEOUT Port Timeout in minutes (0.0120.0) ____________________
TERTIME1 First delay time (0–600 seconds) ____________________
TERSTRING Termination string ____________________
TERTIME2 Second delay time (0600 seconds) ____________________
IPADDR IP address (www[h].xxx[h].yyy[h].zzz[h]) ____________________
SUBNETM Subnet mask (www[h].xxx[h].yyy[h].zzz[h]) ____________________
DEFRTR Default router (www[h].xxx[h].yyy[h].zzz[h]) ____________________
NETPORT Primary network port (A=Port A, B=Port B, D=Disabled) ____________________
FAILOVR Enable fail over mode (Y/N) ____________________
FTIME Network port fail over time (065535 msec) ____________________
NETASPD Network speed, Port A (A=Auto, 10=Mbs, 100=100Mbs) ____________________
NETBSPD Network speed, Port B (A=Auto, 10=Mbs, 100=100Mbs) ____________________
FTPSERV Enable FTP server (Y/N) ____________________
FTPCBAN FTP connect banner ____________________
FTPIDLE FTP idle time-out (5–255 minutes) ____________________
FTPANMS Enable anonymous FTP login (Y/N) ____________________
FTPAUSR Associate anonymous user access rights with user ____________________
T1CBAN Telnet connect banner for host ____________________
T1INIT Allow Telnet sessions to be initiated by the host (Y/N) ____________________
T1RECV Allow Telnet sessions to be received by the host (Y/N) ____________________
T1PNUM Telnet port number for host (port_num = 23 or >= 1024) ____________________
T2CBAN Telnet connect banner for card ____________________
T2RECV Allow Telnet sessions to be received by the card (Y/N) ____________________
T2PNUM Telnet port number for card (port_num >= 1024) ____________________
TIDLE Telnet idle time-out (0–255 minutes) ____________________
HOST1 Alias for host #1 ____________________
IPADR1 IP address for host #1 (www[h].xxx[h].yyy[h].zzz[h]) ____________________
HOST2 Alias for host #2 ____________________
IPADR2 IP address for host #2 (www[h].xxx[h].yyy[h].zzz[h]) ____________________
HOST3 Alias for host #3 ____________________
IPADR3 IP address for host #3 (www[h].xxx[h].yyy[h].zzz[h]) ____________________
HOST4 Alias for host #4 ____________________
IPADR4 IP address for host #4 (www[h].xxx[h].yyy[h].zzz[h]) ____________________
HOST5 Alias for host #5 ____________________
IPADR5 IP address for host #5 (www[h].xxx[h].yyy[h].zzz[h]) ____________________
Courtesy of NationalSwitchgear.com

Table of Contents