SCM CU 300C - Controls

EN
5 - CONTROLS
THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN Cap. 5 Pag. 1/14
INDEX
5.1 Controls board............................................................................................2
5.2 Emergency buttons ....................................................................................3
5.4 General controls before machine starting ..................................................4
5.4.1 Profiling operations ....................................................................................6
5.4.2 Milling at the spindle (shaping)...................................................................6
5.4.3 Tenoning ....................................................................................................6
5.5 Machine start-up - shutdown......................................................................9
5.5.1 Machine with COUNTERCLOCKWISE SPINDLE ROTATION (against feed
direction) ...........................................................................................12
5.5.2 Machine with CLOCKWISE rotation (feed direction)................................12
5.11 Auto-brake motor......................................................................................14