SCM CU 300C - Fitting the Supporting Frame

4 - INSTALLATION
EN
Pag. 16/53 - Cap. 4 THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN
4.3.24 FITTING THE SUPPORTING FRAME
(hd_4.3-24_0.0)
NOTE-INFORMATION:
for transport reasons the frame is demounted from the machine.
1) Insert the support (B fig. 4.3-24) in the groove of the wagon (A fig. 4.3-24).
2) Place the frame (D fig. 4.3-24) on the support (B fig. 4.3-24) and on the pin (F fig. 4.3-24), inserting the two
pads (H fig. 4.3-24) in the groove of the wagon.
NOTE-INFORMATION:
the screw (F fig. 4.3-24) must sit perfectly in the special hole underneath the frame (D fig. 4.3-24).
3) Level the table (D fig. 4.3-24), if necessary, acting on the pin (F fig. 4.3-24).
4) Tighten the knobs (C fig. 4.3-24).
5) Insert the stud bolt (L fig. 4.3-24) with the presser (M fig. 4.3-24) in the groove of the wagon (A fig. 4.3-24)
and turn it clockwise to lock it.
6) When the wagon (A fig. 4.3-24) is not used, lock it with the lever (N fig. 4.3-24).
The table is already registered; to make further adjustments proceed as follows:
- loosen knobs (C fig. 4.3.24);
- loosen screws (P fig. 4.3.24) and move the dowels (Q fig. 4.3.24) to adjust the height position.
Fig. 4.3-24