SCM CU 300C - Telescopic Rule on Tenoning Table; 6.1 Rule Rotation; 6.2 to Move the Rule up to the Tool

9a - OPERATIONS AND ADJUSTMENTS OF SPINDLE
EN
Pag. 10/45 - Cap. 9a THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN
9A.6 TELESCOPIC RULE ON TENONING TABLE
(cu_9a-6_0.0)
NOTE-INFORMATION:
the splinter guard is fixed to the rule with screws (V fig. 9.6).
If the splinter guard becomes worn, move it towards the tool by slackening the securing screws.
If you need to replace it, see Chapter 20.
9A.6.1 RULE ROTATION
(cu_9a-6-1_0.0)
1) Loosen the knobs (F fig. 9.6).
2) For use, position the ruler referring to the plate (P fig. 9.6).
3) Tighten the knobs (F fig. 9.6).
9A.6.2 TO MOVE THE RULE UP TO THE TOOL
(cu_9a_6-2_0.0)
1) Loosen the knobs (F fig. 9.6).
2) Position the telescopic ruler (R fig. 9.6) at the right distance from the tools (U fig. 9.6).
3) Tighten the knobs (F fig. 9.6).